RawringCrafts

Doing dumb crafts

A place where I post about the things I make and related stuff~


Pank's merch shop (I make everything here)
ko-fi.com/pankraru/shop

A bit more niche advice, but if you have a laser cutter/engraver, you no doubt have noticed the layer of sud and ash deposited on top of your work piece.

Easy solution! Vinyl transfer paper! Cover your material with it, firmly press it on and get lasering. Once you're done, just pull it off and Ta-dah! Perfectly clean surface.

Just make sure it is transfer PAPER! Paper will get vaporized cleanly without adding more burned gunk.


You must log in to comment.

in reply to @RawringCrafts's post: