midway through starting to block these out + add more geometry than just Cubes, I realized I JUST learned there's a tool for adding an edge loop. I was starting to do it a lot more manually to separate out the individual teeth and differentiate fangs vs molars vs the short front incisors (which cats also have).
witchy girl/virtual snep
- she/her
- lune.gay/
^ computer witch ^
^ self-taught 3D modeller ^
^ 🏳️⚧️, fan of girls ^
^ old enough ^
^ anarchist 🟥⬛^
- pfp cropped from
by
srnk /
@srnk - banner is three combined refs, each by girlpillz / @girlpillz
see them uncombined here
you can always find me here
lune.gay/the blog specifically
lune.gay/blog/You must log in to comment.
in reply to @lunemercove's post:
if I can ever figure out how to get clips out of vr vrchat easily, I should show how the thumbs look on my current models. it's atrocious. I've never grokked how rigging them works despite staring at my own goddamn thumbs for hours.
in reply to @lunemercove's post:
this is also giving me a chance to figure out what is wrong with the muzzle shape. something has been Off that I couldn't quite identify. I think part of it's that the muzzle was too low on the face, which I am fixing now while preparing to make some teeth blanks.
made a VERY programming mistake adjusting rose's mouth (needed to do it to set up for how the teeth should sit). told blender "cut between these vertices", when they were on opposite sides of disconnected sections (lips). so it took the long way around through the back of the mouth, which I only just realized. there were better ways to do what I wanted, whoops.
in reply to @lunemercove's post:
the way I did teeth on my previous two models was significantly more manual and more painful, for worse results (well, we'll see for sure when I'm done with these, but I'm fairly confident these will turn out better).